Brush Speedselector; Brush Indicator - Hoover SteamVac FH50046 Owner's Manual

2.10 Unlatch back part of tank lid and remove lid,
Empty tank. Pour dirty water out from the rear of the
tank (F).
The lid replaces in a hinge-like manner, Position the
front of lid under tabs (G) on front of tank. Rotate lid
down onto tank, Make sure that the lid is secure on
all sides before placing tank on rJeaner.
• IMPORTANT.
For full suction, it is important that the Dirty
Water Tank lid is properly secured before
cleaning,
BRUSH SPEEDSELECTOR
Your SteamVac _ carpet cleaner has three agitator
brush settings.
HI - for normal cleaning of carpet and bare floors
LO - for gentle cleaning of carpets and bare floors
OFF - for cleaning carpets and bare floors when
brushing is not desired. (See =Picking Up Sp_Bs °
section on page 11.)
Slide selector button to the desired setting before
cleaning,
BRUSH INDICATOR
2,t2 The brush indicator v_lI spin (F) when the
carpet cleaner is tamed ON and the brushes are
rotating.
If the indicator does not spin and the pattern is
visible (G) when the carpet cleaner is turned ON,
the brushes are not rotalJng.
There are three reasons why the brushes may not
be rotating:
1. Brush speed selector set on OFF
(see previous section).
2. Solution tube connected (Fig. 4,3).
3. Brush indicator aoreen dirty,
2.13 To clean screen (H), turn carpet cleaner offand
disconnectfrom elect_cal outlet,
Remove clear Cover and wipe off screen with a
damp cloth.Snap cover back into position.