Afterusing Tool; Aftercleaning - Hoover SteamVac FH50046 Owner's Manual

Hide thumbs Also See for SteamVac FH50046:
Table of Contents

Advertisement

Available languages

Available languages

AFTERUSING TOOL
Drain suction hose by turning carpet cleaner
ON
and holding end of hose up for several seconds, Do
not press tdgger.
Disconnect carpet cleaner from electrical outlet.
4.t3
Drain solution
tube by placing round end in
sink and raising
nozzle above
your head. Press
the trigger.
Proceed with steps c, d and e located in "After
cleaning" section of manual.
4.14
Occasionally,
debris
may
become
lodged
inside of the hose at the conver{er end (L). To c_ean
out the hOSe, lift bottom of converter clip (M) w_th
a screwdriver
and remove clip. Remove debris as
sho_,
4,t5
Snap
clip back
into position making
sure
solution hose (N) is not pinched and moves freely.
4,16
Rap;ace
Dirty Vv_aterTank front panel (O).
Rotate panel upward then push down until it snaps
firmly in place. For full suction it is important that the
front panel is propedy secured before cleaning floor.
4.17 If the front panel is accidentally
removed from
the tank_ it can be easily
re-attached.
Slide the
panel into the channels
(P) and firmly push down
until panel snaps into place,
'
!
,, ,,r_
AFTERCLEANING
Allow carpet or upholstery to dry. To help prevent matting and recoiling the
carpet, keep Children and pets away from surface until it is completely
dry.
If it is necessary to walk on damp carpet, place towels or white cloths on the
traffic areas.
If furniture must be replaced before the carpet is dry, use plastic or aluminum
foil pads under legs of furniture so metal slides or wood finishes will not stain
the carpet.
If desired, the carpet may be rinsed. Rinsing is not necessar/for
cleaning, but
it may improve the surface's appearance
after it is dry.
4.t8 Empty tanks, dnse with clear water and let air dry. Rinse the Clean Water
Solution Tank cap and Dirty Water Tank lid and let air dry,
Remove debris from Dirty Water Tank filter and rinse with dean water.
• IMPORTANT,
I
if the fitter must be removed for cleaning, it is easier to replace if the
filter is wet.
Vacuum thorough{y after carpet has completely dried. This will help reduce any
shading left by the carpet cleaner's brushes.
!
t6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents