Jeep Commander Owner's Manual page 398

Chrysler llc 2009
Hide thumbs Also See for Commander:
Table of Contents

Advertisement

396 STARTING AND OPERATING
Hold down the NEUTRAL "pin" switch (with a pen, etc.)
for four seconds until the LED lamp by the switch starts
to blink, indicating shift in progress. The lamp will stop
blinking (go out) when shift is complete. The "4WD
SYSTEM IN NEUTRAL" message will no longer be
displayed on the EVIC (Electronic Vehicle Information
Center). Refer to "Electronic Vehicle Information Center
(EVIC)" in Section 4 of this manual.
Neutral Switch
5. Shift the transmission into PARK.
6. Start the engine.
7. Shift the transmission into DRIVE.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Commander and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

2009 commander

Table of Contents

Save PDF