Shift Positions; Shifting Procedures - Jeep Commander Owner's Manual

Chrysler llc 2009

Hide thumbs Also See for Commander:

Table of Contents

Shift Positions

For additional information on the appropriate use of each

transfer case mode position, see the information below:

All roads surfaces such as ice, snow, gravel, sand, and dry

hard pavement.

Disengages both the front and rear driveshafts from the

powertrain. To be used for flat towing behind another

vehicle. Refer to "Recreational Towing" in Section 5 of

this manual.

Low speed four-wheel drive. Locks the front and rear

driveshafts together. Forces the front and rear wheels to

rotate at the same speed. Additional traction and maxi-

mum pulling power for loose, slippery road surfaces

only. Do not exceed 25 mph (40 km/h).

4WD HI to 4WD LOW

With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),

key ON or engine running, shift the transmission into

NEUTRAL, and raise the transfer case T-handle. The

"4WD LOW" indicator light in the instrument cluster,

will begin to flash and remain on solid when the shift is

complete. Release the T-handle.

STARTING AND OPERATING 309

Table of Contents

2009 commander