Jeep Commander Owner's Manual page 312

310 STARTING AND OPERATING
NOTE: If shift conditions/interlocks are not met, or a
transfer case motor temperature protection condition
exists, a "CHECK SHIFT PROCEDURES" message will
flash from the EVIC (Electronic Vehicle Information Cen-
ter). Refer to "Electronic Vehicle Information Center
(EVIC)" in Section 4 of this manual.
Shifter T-Handle
4WD LOW to 4WD HI
With the vehicle at speeds of 0 to 3 mph (0 to 5 km/h),
key ON or engine running, shift the transmission into
NEUTRAL, and raise the transfer case T-handle. The
"4WD LOW" indicator light in the instrument cluster,
will flash and go out when the shift is complete. Release
the T-handle.
NOTE:
If shift conditions/interlocks are not met, or a transfer
case motor temperature protection condition exists, a
"CHECK SHIFT PROCEDURES" message will flash
from the EVIC (Electronic Vehicle Information Center).
Refer to "Electronic Vehicle Information Center
(EVIC)" in Section 4 of this manual.
Shifting into or out of 4WD LOW is possible with the
vehicle completely stopped, however difficulty may
occur due to the mating clutch teeth not being prop-
erly aligned. Several attempts may be required for