Table of Contents
Advertisement
FS6300 NMS User Manual
8 • Configuring the 6511RC Card
Configuring E1 Links
Click on E1 Link to configure the line interface, alarm status, DS0 settings, and test settings.
Edit Line Interface Settings
Click on Line Interface (under Current Configuration) in the menu tree for the E1 Link window, then select
the links you want to edit from the TUG3, TUG2, and TU drop-down menus. Make the desired changes,
then click Submit.
View Alarm Status
Click on Alarm Status (under Current Configuration) in the menu tree for the E1 Link window, then select
the links you want to view alarms for from the TUG3, TUG2, and TU drop-down menus.
View Line Statistics
You can view Current, Past, and Total Line Statistics for a link. Navigate to Near End Line Statistics > Cur-
rent, Near End Line Statistics > History, or Near End Line Statistics > Totals in the menu tree for the E1
Link window, then select the links you want to view from the TUG3, TUG2, and TU drop-down menus.
Configure DS0 Settings
Click on DS0 Configuration > Details in the menu tree for the E1 Link window, then select the links you
want to configure from the TUG3, TUG2, and TU drop-down menus (see
Figure 114
on page 131).
Figure 114. 6511RC DS0 Details
If you only want to enable or disable a few DS0 numbers, select the status from the drop-down menu for each
DS0 number you want to change, then click Selective Modify.
If you want to activate all DS0 numbers, click Enable All. If you want to deactivate all DS0 numbers, click
Disable All. A status emssage will display. Click OK.
Configuring E1 Links
131
Advertisement
Table of Contents
