Advertisement
2
+
Remove the worn ink ribbon from its housing.
+
Position the ink ribbon above its housing under the rear cover.
+
Insert the ink ribbon into its housing without removing the adhesive strip (2):
• Position the right-hand (white) end of the main roller onto the retractable axis.
• Position the left-hand (green) end of the main roller onto the left axis.
+
Pull off the adhesive strip (2) from the ink ribbon.
5
6
+
Insert the small roller into its housing:
+
Check that the gear axis (3) is correctly positioned in its slot (4) as is the other axis (5) in its corres-
ponding slot (6).
+
Close the rear cover.
42
2
OR
OR
2
5
6
OR
3
4
Appendix
2
3
4
Advertisement
