Setting Table Square Front And Back Of Blade; Tilting The Table; Fence Adjustment; Adjusting The Rip Fence Guide Scale - Craftsman Professional 119.224010 Owner's Manual

3. SETTING TABLE SQUARE FRONT AND BACK OF
BLADE
Place a suitably sized square against the saw blade on back and
force position. If the table requires adjustment, proceed as follows:
a. Using a wrench, release the flange nut on the lower table
trunnion, (See FIG,14)
b. Place the M5 Hex "L" wrench on the hex. socket set screw and
adjust until the table is square to the saw blade on the front and
back position.(See FIG.14)
b. Horizontal alignment of the rip fence is made by adjusting the
two knurled nuts and the fence adjusting knob.
The fence should be aligned with the table slots along its
length.(See FIG. 17)
[Hex, socket set screw
c. lighten lh,_.,ian_je, . nut and r.ch_.,ck 1he saw fiade and the tr_bie
for squareness,
4. TIJING THE PABLE
For bevel cuts, the table rifts 0 througls 45 degrees.
a. -Io tilt the table, !oosen lhe wing nut on the table trunnion, sel tile
table to the required angle and tigl_ten l!e wing nut again (See FIG.
15).
b. It is recommended to verify the correct angle setting using an
angle guide, or by making trial cuts in scrap wood. Adjust the
indicator accordingly by using a phillips ltead screwdriver.
5, FENCE ADJUSTMENT
a. Vertical alignment of the rip fence is made by adjusting the two
knurled nuts and the fence adjusting knob.
The fence should be adjusted vertically with a suitable square
placed on the table surface.
_-" ,C E
6o ADJUSTMG "THE RiP _=EN_LS GUIDE S AL_s
To ad}ust [he rip fence scale loosen the four wing screws below
the table and move the scale and the guide rail sideways to
adiust. Re4ighLen the wing screws when the adjustment is
correct (See FIG.17)
qh,o adjustment may be checked by setting /-_e ip fence to a
thickness and cutfng a test piece.
When the adjustment is correct the thickness of the test piece will
correctpond with the rip fence scale setIJng,
FIG, !7 ]
7. A©JLISTING THE BLADE TENSION
To loosen the tension of the blade, turn the blade tension knob
counter clockwise and the tension ildicator will be lower. To
tighten the tension of the blade, turn the tension knob clockwise,
and the tension indicator will rise.(See FIG.18)
Tension indicator
8. CHANGING AND ADJUS'TmNG THE SAW BLADE
This bandsaw is factory-equipped with a general-purpose wood
cutting blade, the saw blade is set prior to delivery.
To change the saw blade, the following procedure must be
followed: