GE Profile DPGT750 Owner's Manual And Installation Instructions page 7

Quick Start
www. GEAppliance.L corn
Getting
Started
If the 7buch
Screen is dark,
press POWER
or the 7buch
Screen to access
the dry cycles
O Clean tile lint filtm:
IMPORTANT: Clean the lint filter each
time you use the dryen
Add clothes. Do not overload. This wastes
energy and promotes wrinkling.
O elect one of the four drying methods
from tile Home Screen:
• Press BY FABRIC to dry according to
fabric type.
• Press BY GARMENT to dry according to
clothing type.
• Press SPECIAL CYCLES to dry
nongarment items, to dry without heat
or to dry using the drying rack.
• Press TIMED DRY to specify a drying
time and temperature.
O Change any of the automatic settings,
if desired, by pressing the Touch Screen
and following the on-screen instructions.
By changing the settings you can:
• Change the level of dryness
• Change the drying temperature
• Set a Delay Start or Extended Tumble,
or change the End-of:Cycle Signal
volume
• Adjust time settings
O Close the door and press START.
The dryer will not operate unless the door
is closed.
TOUCH TO SELECT
Sensor DRY CYCLE
BYFABRIC BYGARMENT
\' "Is.EC,AL ": .,MEOORY
_______J CYCLES
_,so m_ "
HomeScreen
SUMMARY SCREEN
COTTONS MORE DRY
mfff
|it,d;
0:36
Washer
Communicated
Cycles
If the Washer/Dryer Communication features
of your washer and dryer are turned ON, your
dryer will receive cycle information from your
washer m create a dry cycle that matches your
wash load.
After the vcash cycle is complete, communication
begins once either the _.asher or dryer Touch
Screen is activated.
Once the information is received, your dryer
can then create the optimal dry cycle for your
load. You can then change any of the automatic
cycles, as desired.
NOTE: For some communicated wash cycles,
your dryer will prompt you to select a FABRIC
TYPE.
See "Final Setup" in the Installation lnsn'uctions
for attaching the serial cable for Washer/Dryer
Communication.
nnnm ,
SENDING iNFO TO DRYER.,,
Washer Display
RECEIVING,,.
Dryer Display