GE Profile DPGT750 Owner's Manual And Installation Instructions page 30

Installation Instructions
EXHAUSTING THE DRYER (cont.)
WARNING
The correct exhaust installation is your
responsibility.
USE ONLY METAL 4" DUCT. DO NOT USE
DUCT LONGER THAN SPECIFIED IN THE
EXHAUST LENGTH TABLE.
Ducting longer than 150 equivalent feet will:
• Increase the drying times and the energy
cost.
• Reduce the dryer life.
• Accumulate lint, creating a potential fire
hazard.
EXAMPLE ONLY
The following chart describes an example of
one possible ductwork installation.
Problems due to incorrect installation are not
covered by the warranty.
The length of the exhaust system depends
upon the type of duct, number of turns and
the type of exhaust hood (wall cap), and all
conditions noted below. Both rigid and flexible
metal ducts are shown in the table.
For satisfactory air movement, the total duct
length should not exceed 150 equivalent feet.
-J
_o_
ii°
t r"
w
>-
a
v
Z n
m_
£-4,
SO
EQUIVALENT
RIGID NUMBER
DUCT PIECES LENGTH X USED
1 Ft. X (4) Rigid Metal
Ducting
(Preferred)
Elbows
(90°/45 o)
Turns Less
Than 4 Ft.
10 Ft. X (3)
2 Ft. X (1)
_ Rigid Ducting 1 Ft. X (5)
_ _ 4" Wall Cap 5Ft. X (1)
I,,°;4-
Total Ductwork Length
TOTAL MUST BE LESS THAN OR EQUAL TO 150 FT.
EQUIVALENT
= LENGTH
= 4 Ft.
= 30 Ft.
= 2 Ft.
= 5 Ft.
= 5 Ft.
= 46 Ft.
3O