GE Profile DPGT750 Owner's Manual And Installation Instructions page 10

Summary Screen
www. GEAppliances. corn
About the
Drying
Options
Touch the OPTIONS pad on the Touch Screen
to select drying options. After selecting any drying
options, press OK to save your setting.
Delay Start
Touch the DELAY START pad repeatedly to set a
delay time of up to 12 hours. The countdown time
will be shown in tile display.
Extgn&d Tumble
Minimizes wrinkles by adding approximately
20 minutes of no-heat tumbling after clotlles are
dry. Touch EXTENDED "IXIMBLE to turn tile
fizature on or of[i If set, the Extended Tumble time
will not be included in the cycle time shown in the
display. The dryer will signal for tile first 6 minutes
during Extended Tumble.
End.of-CycleSignal
Alerts you that tile cycle is complete. The clothes
should he removed when the beeper goes off so
wrinkles won't set in. Touch END OF CYCLE
SIGNAL to select the volume or to turn the
beeper off. The new volume will be saved as the
default setting.
OPTIONS m
_ EXTENDED TUMBLE
Adjusting the
7_me Settings
You can adjust the time setting fbr the dry cycle,
delay start and extended ramble times. Touch the
TIME pad on the Summary Screen; then choose
the time you wish to adjust.
To change the dry cycle time, select CYCLE TIME;
then use the arrows to select more or less drying
time. If the Cycle Time is changed, the dryness
sensor will be turned off.
To change the delay start or extended tumble time,
select DELAY TIME or EXTENDED TUMBLE;
then follow the instructions in the About the
Drying Options section.
ADJUST TIME SETTINGS
[ CYCLE TIME [ DELAY TIME ]
[ EXTENDED TUMBLE ]
About the
Cycle Status
Screen
After you press START, a Cycle Status screen will
appear to indicate what cycle the dryer is in and
the time remaining in the cycle.
DRYING - The dryer is sensing the moisture level
of the load.
SENSING - The dryer is determining if the correct
dryness level has been reached.
COOL DOWN - The load is dry and may be
removed (the dryer will continue to blow cool air
fbr up to 5 minutes).
EXTENDED TUMBLE - The load is dry and may
be removed (the drum will continue to turn
without heat for up to 20 minutes).
CYCLE STATUS
:32
DRYING
[SE_INGS CHANGE"
f0