Table of Contents
Advertisement
cki "rigand Oh
"
ecking Contents
......................
Tools Needed
Combination Square must be true. Check it's
accuracy as shown below.
Utility Knife
Select the straight edge of
Draw fight line on
314"thick board. This edge
board along edge
must be perfectly straight.
PIiers
Phillips Screwdriver
Medium Screwdriver
Small Screwdriver
Combination Wrenches
7/16 In. 1/2 In. 9/16 In.
Tape Rule
Hex "L" Wrenches
3/32 In., 1/8 in., 5/32 In.
r
J
U
NOTE: The square and
straight edge are used to
align the saw. They must
be accurate if the saw is
to be aligned properly.
Should be no gap or overlap here when square
is flipped over in dotted position.
"Jlll'tllJ,'lll,t*l|,*ll|,,llJ,=lll,llfJ,ljll
Framing Square
Combination
Square
_: i',_'. : "' ..........
Unpacking
1_Separate saw and all parts from packing materials and
check each one with the illustration and the "List of
Loose Pads" to make certain all items are accounted
for, before discarding any packing material,
j-WARNING: ff any parts are missing, do not attempt J
i to assemble the table saw, plug in the power cord
or turn the switch on until the missing
parts are I
_btained
and are installed correctly.
J
NOTE: Before beginning assembly:
° Check that all parts are included. If you are missing any
part, do not assemble the saw. Contact your Sears Ser-
vice Center to get the missing part.
• Sometimes small parts can get lost in packaging mate-
rial. Do not throw away any packaging until saw is put
together.
Check packaging
for missing parts before
contacting Sears.
• A complete parts list (Repair Pads) is at the end of the
manual. Use this list to identify the part number of the
missing part,
4
3, Apply coat of paste wax to the table and table exten-
sions.
10
I
Hide quick links:
Advertisement
Table of Contents
