Installing Indicator - Craftsman 113.299315 Owner's Manual

lnstamBing indicator
1. From the bag labeled "Miscellaneous" remove the fol-
lowing hardware:
"1 Plastic indicator
"1 Pan Head Screw, 10-32 x 1/2" Long
"1 Flat Washer, 13/64 x 5/8 × 1/32
"1 Square Nut. 10-32
Items marked with an asterisk (*) are shown actual
size.
2. Install the pan head screw with washer through the
hole in the plastic indicator with the red line facing
down. Install the square nut in the pocket behind the
indicator recess in the fence head as shown,
3. Thread the pan head screw intothe square nut. Do not
tighten.
4. Place rip fence on saw table so that it lightly touches
the right side of the blade and lock it in this position.
5. Adjust the indicator so that the red line is located over
the "Zero" line of the right rip scale and tighten screw.
Ind icator
10-32 x 1/2
Pan Head Screw
[_ 13164 x 5/8 x
1132
Fiat Washer
10-32
Square Nut
.j_ Pan Head Screw
. I-- Fiat Washer
Indicator J '_._ /_Square Nut
Fence Head j==_=
L_ = _l
cat_¥
Recess
"Nut
Pocket
21