Advertisement
Display 80 - Reset and restart timers
**************
*
*
TIMERS
*
RESET
*
**************
With this display all timers of display 82 can be reset.
These timers will be automatically reset after the battery has been fullycharged and the
charger is disconnected. Thus it's not always nece ssary to use the display 80.
Display 81 - Enable or disable timers
**************
*
*
TIMERS
*
XXXXXXXX
*
**************
This display will start or stop the timers.
On power off the values of the timer displays are stored onto the EEPROM, where they will be
read during power on. To initialize the counters to zero, use display 80. Timers will be
automatically disabled when recharge
Also the current state of timer disabling/enabling is stored onto the EEPROM.
Display 82 - Test timer display
++++++++++++++
+aaaaa bbbbb +
+ccccc ddddd +
+ TIMERS eee +
+
++++++++++++++
aaaaa
timer for how long the phone has been powered on
bbbbb
timer for how long the phone has been in service
ccccc
timer for 'no service, power save'-state
ddddd
timer for how long the transmitter has been on
eee
state of timers, ON/OFF
All the values are shown in one minute resolution. The accuracy of the timers is about one
second. The display uses following format for timers:
HHHMM
where HHH is hours and MM is minutes.
All timers of this display will be reset if the charger is disconnected from the mobile with
fully charged battery. The maximum value of the timers is 99 h 59 min. When 'powered on'
timer has reached value 9959, all timers will be stopped.
NOTE: When the maxium usage time of the phone is required (e.g. idle time measurement) then
ALL field test displays must be deactivated!
##############
*
#
Use menu
*
#
to reset
*
# field test #
*
#
timers
##############
*
*
*
XXXXXXXX := ENABLED or DISABLED
*
battery message is reached.
##############
#PwrOn InServ#
#NSPS
TxON
#
Timers
+
#
Status
##############
#
#
#
#
#
#
26
Advertisement
