Advertisement
Display 45 – Toggle transmitter functionality
**************
*
*TRANSMITTER *
*
XXXXXXXX
*
**************
This display has no effect in 7110 phone, irrespective of the displayed status the
transmitter is always switched on.
When selected, this display disables transmitter functionality if enabled and vice versa.
New setting is valid until next power off or until new execute of this display.
This FTD can be used to simulate easily situations when the MS can hear the network (i.e.
receiving signal is good enough), but the network can not receive any messages from the MS.
Location updating attempts or MO call establishment attempts can be failed (random access
failure) by this FTD and field testing of these failures is much easier now.
Next periodic location updating can be checked from the display 10 (chapter 3.1.10) by
taking the difference of current T3212 counter value and T3212 timeout value.
Display 51 – SIM information
++++++++++++++
+aaa bbb ccc +
+ dddddddd
+ f g
hh ii +
+
j
kkkk
++++++++++++++
aaa
SIM voltage selection type (5, 3 or 3/5)
bbb
SIM baudrate (372, 64, 32 or 0)
ccc
Clock stop allowed, Yes or No
dddd
Clock stop condition, Up/Down/xxxxxxxx if no preferred level
f
PIN1 attempts left (0,1,2,3)
g
PIN2 attempts left (0,1,2,3)
hh
PUK1 attempts left (0-10)
ii
PUK2 attempts left (0-10)
j
ATR retransmission counter (0-9)
kkkk
Transmission frame/parity errors,
Display 54 – Block display 1
++++++++++++++
+aa bb
aa bb+
+aa bb
aa bb+
+aa bb
aa bb+
+aa bb
aa bb+
++++++++++++++
1. row: Block set 1, block set 2
2. row: Block set 3, block set 4
3. row: Block set 5, block set 6
4. row: Block set 7, block set 8
aa
Number of reserved blocks
bb
Number of free blocks in worst case
*
*
XXXXXXXX
*
##############
#VSel Bau SAl#
+
#SCond
#PIN12
+
# ATR
FE/PE #
##############
##############
#ResF1
#ResF3
#ResF5
#ResF7
##############
ENABLED or DISABLED
CStop#
PUK12#
FE/PE + hexadecimal count
ResF2#
ResF4#
ResF6#
ResF8#
17
Advertisement
