Unpacking And Checking Contents; Tools Needed; List Of Loose Parts - Craftsman 113.298722 Owner's Manual

unpacking and checking contents
TOOLS NEEDED
Plier
Combination Square
Wrenchea
7/16 in, 1/2 in. 91"16 In.
Phillips Screwdriver
Medium Scra_dr|ver
Small Screwdriver
SIZE
Set Screw Wrenches
3/32 In.
1/8 In.
5/32 In.
COMBINATION SQUARE MUST BE TRUE,
STRAIGHT EDGE OF BOARD
3, 4" THICK. THIS EOGE MUST
BE PERFECTLY STRAIGHT.
DRAW LIGHT LINE ON _
BOARD ALONG THIS EDGE ; '_ _ /
L_ /
SHOULD BE NO GAP OR OVERLAP
HERE WHEN SQUARE IS FLIPPEO
OVER IN OOTTED POSITION.
r
Separate all parts from packing materials and check
each one with the illustration and the list of Loose Parts
tO make certain all items are accounted for, before
discarding any packing material.
I WARNING: ff any parts are missing, do not at-
tempt to assemble the table saw, plug in the
power cord or turn the switch on until the missing
parts are obtained and are in_alle,(:l correctly.
Remove the protective oil that is applied to the table top
and edges of the table. Use any ordinary householdtype
grease and spot remover.
WARNING: To avoid fire or health hazard, never ]
use gasoline, naptha, or similar highly volatile
i
solvents.
Apply a coat of automobile wax to the table.
Wipe all parts thoroughly with a clean, dry cloth,
WARNING: For your own safety, never con_ !
plug to power source outlet until all assembly
!
stepsarecomplete, aad you have mad and under-
stand the safety and operating Instructions.
H
J
ITEM
A
B
C
D
E
H
M
Q
R
S
T
U
G
J
AM
F
K
L
N
O
P
il/ ..........
14
PART NAME QTY.
Blade Guard and Spreader ........................... 1
Rip Fence ...................................................... 1
Owner's Manual ............................................ 1
Cast Iron Table Extensions ........................... 2
Miter Gauge .................................................. 1
Rip Fence Guide Bar with Rip Scale (Front]. 1
Support, Motor Base ..................................... 1
Rip Fence Guide Bar (Rear) ......................... 1
Side Stiffener ................................................. 2
Leg ................................................................ 4
End Stiffener ................................................. 2
Motor ............................................................. 1
Bag of Loose Parts
(Containing the following items)
Outlet, On/Off with Key ................................ 1
Handwheel .................................................... 2
Bracket, "L" Mounting (Model 113.298721) ... 1
Bag of Loose Parts ........................................ 3
Bag of Loose Parts
(Containing the following items)
Wrench .......................................................... 1
Belt, "V" 1/2 x 41 ........................................... 1
Pulley, 112dia. with 5/8 Bore ......................... 1
Spreader, Rod ............................................... 1
Blade Guard Support .................................... 1
Spreader Support .......................................... 1
£@
(MODEL 11_L29B762)
u
(MODEL 113.298722 i
8