Table of Contents
Advertisement
basic saw operation
DADOING
Instructionsfor operating the Dado Head are contained
in booklet furnished with the Dado Head.
The arbor on the saw, is only long enough so that the
widest cut that can be made is 13/16 inch wide.
It is not necessary So install the outside loose collar
before screwing on the artx>rnut. Make sure the arbor
nut is tight.
ALWAYS USE DADO INSERT LISTED UNDER "REC-
OMMENDED ACCESSORIES."
When using the Dado Head it will be necessary to
remove the Blade Guard and Spreader.
USE CAU-
TION.
USE MITER
GAUGE,FENCE,
FEATHER-
BOARDS OR PUSH STICKS, etc. AS REQUIRED.
WARNING:
For your own safety, always replace
]
the blade, guard and spreader when you are
I
finished dadoing.
LOOSE COL!.
Ill
ARBOR
I
iU
SAW ARBOR
REMOVE SAWBLADE
AND
INSTALL
DADO HEAD
BACK
OF SAW
MOLDING CUTTING
Instructions for operating the Molding Head are con-
tained in a booklet furnished with the Molding Head.
Always use the Molding insert listed under "RECOM-
MENDED ACCESSORIES'.
When using the Molding Head, it will be necessary to
remove the Blade Guard
and Spreader.
USE CAU-
TION.
USE MITER
GAUGE.
FENCE,
FEATHER-
BOARDS OR PUSH STICKS,
ETC, AS REQUIRED.
j WARNING:
For your own safety, always replace I
the blade guard and spreader when you are fin-
I
I_ted molding.
USING FEATHERBOARDS
FOR NON-
THRU SAWING
Featherboards are not employed during non thru-saw-
ing operations when using the Miter Gauge.
Use Featherbaords
for all other non thru-sawlng
operations
(when sawbladeguard must be removed).
Feath erboards are used to keep the work in contact with
the fence and table as shown and to stop kickbacks.
Add 7-1/2 inch high flat facing board tothe fence, the full
length of the fence. Mount Featherboard to fence and
table as shown, so that leading edges of Featherbaords
will support workpiece until cut is complete, and the
"C"CLAMPS
FEATHERBOARD
"C
CLAMPS
"C'_CLAMPS
WORK
Stick, as in ripping.
Before starting the operation (switch "OFF" and cutter
belowtable
surface):
1. Install Featherboards se they exert pressure on the
workpiece; be positive they are secure and
2. Make sure by trial that the Feathe_boards will stop a
kickback if one should occur.
Replace the sawblade guard as soon as the non thnu-
sawing operation is complete.
38
Hide quick links:
Advertisement
Table of Contents
