Warranty; Safety Instructions For Table Saw - Craftsman 113.298722 Owner's Manual

FULLONEYEARWARRANTY ONCRAFTSMAN T ABLESAW
If wlth|noneyearfromthedaleof purchase, this Craftsman Table Sawfallsdue
to a defect in
mstedal or wo_manshlp, Sears will repair it, free of charge. This warranty applies only while this
product is in use in the United States.
WARRANTY SERVICE IS AVAILABLE BYSIMPLY CONTACTING THE NEAREST SEARS SERVICE
CENTER/DEPARTMENT THROUGHOUT THE UNITED STATES.
THIS WARRANTY APPLIES ONLY WHILE THiS PRODUCT iS USED IH THE UNITED STATES.
This warranty gives you specific legal rights, and you mayalso have other rights which vary from
state to state.
SEARS, ROEBUCK AND CO., D/817 WA Hoffman Estales, IL 60195
v .....
safety instructions for table saw
Safety is a combination of common sense, staying alert
and knowing how your table saw works. Read this
manual to understand this saw.
BEFORE USING THE SAW
serious, permanent Injury, do not plug the saw In
until the following steps have been satisfactorily
completed.
Guard, Spreader, Anti-Kickbackdevice, Miter Gauge,
Fence, Table Insert and Blade Elevation and Bevel
Controls. (See page 25)
4. GROUND THE SAW- This saw has an approved 3-
conductor cord and a 3-prong grounding type plug.
The plug fits grounding type outlets desig ned for 120
volt 15 amp circuits. The green conductor in the cord
isthegrounding wire. To avoid electrocution, NEVER
connect the green wire to a live terminal.
5. To avoid injuryfrom electrical shock, make sure your
fingers do not touch the plug's metal prongs when
plugging in or unplugging the saw.
6. To avoid back injury, get help or use recommended
casters when you need to move the saw. Always get
help if you need to lift the saw. Hold the saw close to
your body. Bend your knees so you can lift with your
legs, not your back.
7. NEVER STAND ON TOOL. Serious injury could
occur ifthe tool tips or you accidentally hit the cutting
4. Review of the maintenance methods for this saw. tool. Do not store anything above or near the tool
(See page 43) where anyone might stand on the tool to reach them.
Read the DANGER label found on the front of the saw, BEFORE EACH USE:
anything.
2. To avoid injury from unexpected saw movement:
B. Check for alignment of moving parts, binding of
A. Put the saw on a firm level surface where there is moving parts, breakage of parts, mounting, and
i
• _ua r_j . p gL,_rd down and i_ 7. When rtppixtg. use push stick when
II:_ _ goggles that meet place f_r through cut_ fence ,Is set 2 _nches or more from
ANSI 2:871 standa_s. 5. Do not do freehamd cuts. bla6_.
E 3. _notDo trot macfi around Or over saw 6. Keep hands out of path of saw 8. Know how to reduce the risk af
9. When riPPing, use push blOCk and 10. Turn _0owex off and walt fo_ blade
auxiliaw fence wherl fence _s set to stop before adjusting or
between V2 and 2 irt_hes from
blade. Do not nlake rip cuts
|
narrower than _/2 inch __