Unpacking And Checking Contents; Tools Needed - Craftsman 113.248340 Owner's Manual

Unpacking and Checking Contents
Tools Needed
Tools required for assembly and alignment:
o Combination Square
• 10ram and 14mm combination wrench
Adjustable wrench.
• #1 and #2 Phillips screwdrivers
o Straightedge
Combination Square
#1 Phillips Screwdriver
Adjustable Wrench
lOmm Combination Wrench
14ram Combination Wrench
#2 Phillips Screwdriver
Combination Square Must be True
Straight Edge of
Draw Light Board 314" Thick
Line on Board This Edge Must be
Along this Edge _ _ . Perfectly Straight
Should be no Gap or Overlap when Square
is Flipped Over in Dotted Position
Unpacking
WARNING: To avoid injury from unexpected start-
ing or electrical shock, do not plug the saw in until
all assembly and alignment steps are complete.
The power cord must remain unplugged whenever
you are working on the saw.
Unpacking and Checking Contents
1 Separate all "loose parts" from packaging materials
and check each item with "Table of Loose Parts" to
make sure all items are accounted for, before discard-
ing any packing material.
WARNING: if any parts are missing, do not attempt !
to assemble the band saw, plug in the power cord, I
or turn the switch on until the missing parts are I
obtained and are installed correctly. ]
2. Sometimes small parts get lost in packaging materials.
Do not throw away any packaging until your saw is put
together. If your are missing a part, check packaging
before contacting Sears.
7