Cutting Panels; Rabbeting; Ploughing And Molding - Craftsman 113.298722 Owner's Manual

CUTTING PANELS
When cutting panels (whenever fence is positioned
outside of table sudace), ALWAYS use the Auxiliary
Fence/Work Suppod.
1. Unlock Fence and raise rear end.
2. Position Auxiliary Fence/Work Support as shown and
attach it with two "C" clamps.
AUXILIARY PANEL/
RABBETING
RABBETING is known as cutting out a section of the
comer of a piece of material, across an end or along an
edge.
To make a RABBET requires cuts which do not go all the
way through the material. Therefore, the Blade Guard
must be removed.
1. Remove Blade Guard.
2. For rabbeting along an edge (long way of work-
piece) as shown, add facing to Rip Fence approxi-
mately as high as the workpiece is wide. Adjust Rip
Fence and blade to required dimensions; then make
first cut with board flat on table as any rip(type) cut;
make second cut with workpiece on edge. Follow all
precautions, safety instructions, and operational in-
structions as for ripping, or rip type operations, includ-
ing Featherboards and Push Stick, etc.
3. For rabbeting across an end, for workpiece 10-1/2
inches and narrower, make the rabbet cut with the
board flat on the table. Using the Miter Gauge fitted
with a Facing, follow the same procedures and in-
structions for cross cutting making successwe cuts
across the width o! the workpiece to obtain the de-
sired width of cut. DO NOT use the Rip Fence for
rabbeting across the end.
I WARNING: For your own safety, Install blade
guard Immediately upon completion of rabbeting
operation,
Rabbet cuts can also be made in one pass of the
workpiece over the cutter using the Dado Head or
Molding Head.
RABi
_FIRST CUT 1
SECOND CUT
,f
/
/
RABBL_'ING ALONG
THE EDGE
/
/
,J
/
/
/
/
/
/
t
RABBETING
ACROSS THE END
PLOUGHING AND MOLDING
PLOUGHING is grooving with the grain the long way of
the workpiece, using the Fence. USE featherboards
and push sticks as required.
PLOUGHING
MOLDING is shaping the workpiece with the grain the
long way ot the workpiece, using the Fence, Use
featherboards and push sticks as required,
MOLDtNG
37