Assembling Storage Hangers; Hex Nut (5/16-18); Hex Bolt (5/16-18 X 5/8 In.); Hex Bolt (5/16-16 X 1-1/4 In.) - Craftsman Professional 315.228510 Owner's Manual

• Slide the square head bolts into the slots from the
right end of the front and rear rails.
• Slide the separator to the left until it is 5 in. or more
from the extension table.
• Measure the distance from the separator to the
extension table at both the front and rear rails and
adjust to make the distances the same.
• Tighten all nuts on the brackets with a 12 mm
wrench.
SQUAREHEADBOLT
-HExNUT
_ SEPARATOR
_ ___ _CHANNEL
HEX BOLT HEXNUT
REARRAIL i \
BRACKET
FRONTRAIL
Fig. 18
ASSEMBLING STORAGE HANGERS
See Figure 19.
The large hangers are for storing the rip fence and the
small hangers are for storing the miter gage.
• Locate the storage hangers, and the following
hardware:
4 carriage bolts (5/16-18 x 1-1/4 in.)
4 hex nuts (5/16-18)
SEPARATOR I
SMALL
STORAGEHANGER
• On the front at the top of the leg stand, remove one
of the lower carriage bolts. See Figure 19.
• Insert a longer 1-1/4 in. bolt in a small hanger and
install in front leg. Attach the nut from the back and
tighten. Repeat for the other small hanger.
• Install the large hangers on the left side. See
Figure 19.
INSTALLING THE MICRO-ADJUST
See Figure 20.
The micro-adjust indexes the rip fence. It includes a
gear on the rip fence and gear racks mounted to the
front rail.
Locate the micro-adjust assembly, two racks, and
the following hardware:
10 pan head screws (10-32 x 3/8 in.)
8 square nuts (10-32)
• Hold a rack so the teeth point down and insert the
pan head screws from the bottom. Put a square
nut on each screw. Finger tighten, leaving a small
gap between the nut and the rack.
• Still holding the rack with teeth down, slide the
square nuts into the right side of the front slot of
the front rail until the end of the rack is near the
center of the table.
• Slide the other gear rack into the front rail from the
left until the two racks meet in the middle. Securely
tighten screws.
Note: The two racks must be touching for the micro-
adjust assembly to roll from one gear rack to
the other.
LARGE
STORAGEHANGER
Fig. 19
CRAFTSMRN" TABLE SAW315.228510 24