Assembling Table Saw To Stand; Folding The Stand For Transport Or Storage - Craftsman 137.415030 Operator's Manual

5. Check to be sure the stand lock
lever (5) is in the slot of the cover
plate (6). (Fig. D)
Fig. C
1
9
Fig. D
ASSEMBLING TABLE SAW TO
STAND (FIG. E)
1. Lift the saw body (1) and place
on the stand (2), aligning the four
mounting holds (3) on the saw base
with the four threaded mounting
holes on the top plate of stand.
2. Attach the table saw to the stand
with four hex head bolts (4) and
washers (5).
3. Tighten all mounting bolts with a
13 mm wrench.
2
7
4
stand lock lever
release direction
NOTE: Do not overtighten the four
bolts as this may cause damage to
the base of the saw.
Fig. E
3
2
6
4. Place the stand on a level surface
and adjust the leveling foot (6)
located on the left front stand leg.
Adjust until all legs are contacting
the floor and are at a similar angle
to the floor.
NOTE: Before using the saw, verify
that the table saw is securely locked
5
in position.
6
FOLDING THE STAND FOR
TRANSPORT OR STORAGE
(FIG. C, D, F)
1. Lift slightly the right side of table
saw (8 - Fig. F), raise the cover
plate (6) on the right side of stand,
pull the stand lock lever (5) to the
right as the release direction, and
then move the saw slowly close to
the wheel. (Fig. D)
2. Rotate the hook (2) to the stop
screw (3) to secure the legs of the
stand in position. (Fig. C)
3. Rest the right side of the saw onto
the floor.
4. Fold the leg set (1) close to the
base until the leg clamp (9) holds
the right side leg. (Fig. C)
21 21
1
4
5
3