Configure Additional Logical Paths - HP XP P9500 User Manual

Table 25 Sample settings
Round Trip Time
between MCU
RCU[ms]
0
30
100
If using XP12000 Disk Array/XP10000 Disk Array: Set the following parameters using use
the System Option window.
Maximum Initial Copy Activity
Path Blockade Watch
16. Click Set.
17. Review the Preview list. To change a path, right-click it in the Preview list and select Modify.
Make any changes in the Add Path dialog box then click Set. To delete the added logical
path(s), right-click it in the Preview list and select Delete.
18. When satisfied, click Apply. This saves the configuration.

Configure additional logical paths

You can configure additional logical paths as needed. A maximum of eight logical paths are
supported.
Prerequisite information
Logical paths can be added from the main or remote system.
Please review the path-related prerequisites in
(page 46).
Procedure 2 To configure additional logical paths
1. On the menu bar, click Actions > Remote Copy > Continuous Access Synchronous for Mainframe
> RCU Operation. The RCU Operation window opens.
2. Change to Modify mode by clicking the
3. In the Display box, select MCU&RCU.
4. In the tree, open the main system CU grouping and CU, then select the desired RCU.
5. In the list area, right-click, then select Add Path from the menu. The Add Path dialog box
displays.
Line Speed b/w Number of Lines
MCU/RCU b/w MCU/RCU
[MB/ms]
0.1 4
0.1 4
0.1 4
Initial Copy Pace Number of Maximum
Initial Copy VOLs
15 64
15 64
15 64
"Configure disk arrays and define logical paths"
icon.
Configure additional logical paths
Round Trip
Time
Specified[ms]
160
220
360
51