HP XP P9500 User Manual page 108

The CreateHrcPair command only creates the pair. You must run the StartHrcPair command
after establishing the pair to start the remote copy process.
The CreateHrcPair parameters are:
CreateHrcPair∆$Dev= M-VOL device list
,$RcuSn= Serial number list
,$RcuSsid= SSID number list
,$Rdev= R-VOL device list
[,$CopyPace= Initial copy pace list]
[,$CopyMode= Initial copy mode list]
[,$Sync= Sync level list]
[,$CTG= CT group list]
[,$Priority= Priority list]
[,$Fence= Fence level list]
[,$OptCfw= CFW flag list]
[,$OptSusDfwBlk= DFW flag list]
[,$OptErrLv= Error level list]
[,$TimeSave= Time-Saving Mode flag]
[,$Diff= Differential management measurement flag list]
[,$TimeStamp= Time stamp transfer list]
The Details for the arguments are:
M-VOL device list (numeric): L x 0x10000 + C x 0x100 + VV, where L=LDKC#, C=CU#,
VV=vol# within CU.
Serial number list (string): RCU serial number (serial number is five digits decimal 0-9). Do not
specify more than 12 RCUs.
SSID number list (numeric): RCU SSID (four digits hexadecimal).
R-VOL device list (numeric): L x 0x10000 + C x 0x100 + VV, where L=LDKC#, C=CU#,
VV=vol# within CU.
When you write M-VOL device list or R-VOL device list, you can omit LDKC# if the LDKC# is
0. For example, you can write 0x0102 when LDKC# is 0, CU# is 1, and vol# is 2.
Initial copy pace list (string): "CP_MIDDLE" = 3 tracks; "CP_FAST" = 15 tracks; default =
CP_FAST. Initial copy pace list (string): "CP_MIDDLE" = 3 tracks; "CP_FAST" = 15 tracks;
default = CP_FAST.
Initial copy mode list (string): "E" = entire volume; "N" = none; default = E.
Sync level list (string): "S0" or "Synchronous0" ; default = S0.
Priority list (numeric): Priority of initial copy operation (1 -256); default = 32.
Fence level list (string): "N" or "Never" = never; "S" or "Status" = status; "D" or "Data" =
data; default = "Never". For async pairs you must either specify N (never) or omit this
parameter.
CFW flag list (numeric): 0 = copy CFW data to R-VOL; 1 = only M-VOL; default = 1.
DFW flag list (numeric): 0 = DFW not required; 1 = DFW required; default = 0. Must be
omitted for async pairs.
Error level list (string): To maintain interchangeability with the script made with the model
before XP12000 Disk Array/XP10000 Disk Array, this parameter has been left. Do not use
this parameter with P9500.
108 Continuous Access Synchronous Z scripting