Using The Remote Control; Putting Batteries In The Remote Control; Operating The System From The Remote Control - JVC TH-V70 Instructions Manual

Using the remote control
The remote control makes it easy to use many of the functions of the system at a distance of up to 7 m (23 feet) away.
• You can also operate other components from the remote control supplied with this system.
- To operate your TV, see page 20.
- To operate your VCR, CATV convertor, or DBS tuner, see page 69.
Before using the remote control, put two supplied batteries first.
1 On the Back of the
remote
control, remove the Battery cover.
2 Insert Batteries.
• Make sure to match the polarity: (+) to (+) and (-) to (-).
Replace the cover.
1
3
2 3
If the range or effectiveness of the remote control decreases, replace the batteries. Use two R6P (SUM-3)/AA (15F) type dry-
cell batteries.
CAUTION:
Follow these precautions to avoid leaking or cracking batteries:
• Place batteries in the remote control so they match the polarity: (+) to (+) and (-) to (-).
• Use the correct type of batteries. Batteries that look similar may differ in voltage.
• Always replace both batteries at the same time.
• Do not expose batteries to heat or flame.
Aim the remote control directly at the remote sensor on the center unit.
• To control other components, aim the remote control directly at the remote sensor on each component.
Refer also to their instruction manuals.
• To operate the remote control properly, do not hide the remote sensor by placing any obstruction.
N
When the center unit is placed vertically
Remote sensor
When the center unit is placed horizontally
NOTE:
When the moving panel is open, the remote
sensor looks up, so the remote control may not
work.
You can use the remote control while the moving
panel is shut.
19