Nikon COOLPIX S9300 Reference Manual page 39

Step 1 Turn the Camera On
Turning the Camera On and Off
• When tile camera is turned on, tile power-on lamp (green) lights and tile
monitor is turned on (the power-on lampturns offwhen the monitor is turned
on).
• To turn offthe camera, press the power switch. Both the monitor and the
power-on lamp are turned off.
• To turn on the camera in playback mode, press and hold the [] (playback)
button. At this time, the lens does not extend.
[] Power Saving Function (Auto Off)
If no operations are per_rmed _r a while, the monitor will turn off, the camera will enter standby
mode, and the power on lamp will flash, If no operations are performed for another three minutes,
the camera will turn off automatically.
To turn on the monitor again in standby mode, perform either one of the following operations,
• Press the power switch, shutter release button, [] button, or • (_ movie record) button,
• Rotate the mode dial,
Flashes
to
o
o
o_
No operations
performed.
No operations
performed.
oao_
3 min
Camera enters
standby mode.
• The time that elapses before the camera enters standby mode can be changed using the Auto off
setting in the setup menu (_101).
• By default, the camera enters standby mode in about one minute when you are using shooting
mode or playback mode.
• if you are using the optional AC Adapter EH 62F, the camera enters standby mode after
30 minutes. This setting cannot be changed,
Camera turns off.
21