Nikon COOLPIX S9300 Reference Manual page 113

Starting GPS Data Recording
w
L_ Notes on GPS
• When positioning for the first time, when positioning was unable to be performed for about two
hours, or after the battery was changed, it takes a few minutes to obtain the position information.
• if Record GPS data is set to On while a log is recorded using Create log (_98), GPS functions
even when the camera is turned off,
• Positions of the GPS satellites change constantly. You may not be able to determine the position
or it may take some time depending on your location and the time, To use the GPS feature, use the
camera in an open air area with few obstacles in the sky, Signal receiving will be smoother if the
GPS antenna ([]_2) is facing the sky,
• If the camera needs to be turned off inside an airplane or hospital, set the Record GPS data to ch
Off.
rn
• The following locations which block or reflect signals may result in failed or inaccurate positioning,
Inside buildings or in the basement of buildings
Between high rise buildings _"
9
Under overpasses
Inside tunnels i
Near high voltage electrical power lines "_
Between clusters of trees o
o
Underwater
• Using a mobile phone of 1.5 GHz band near this camera may disrupt positioning, x
u_
• When carrying this camera around while positioning, do not place it in a metal bag. Positioning
cannot be performed if the camera is covered with metal materials, o
• When there is a significant difference in the signals from the GPS satellite, there could be a o
<Z
deviation of up to several hundred meters.
• Be aware ofyour surroundings when positioning.
• The date and time of the ca mera's internal clock at the time of shooting is recorded at the date
and time of recording indicators displayed on the camera during playback. The time obtained by
the position information and recorded on images will not be displayed on the camera,
• Position information wil be recorded on the first frame of pictures shot using continuous shooting
mode.
• The Geodetic system for this camera's GPS function uses the WGS 84 (World Geodetic System
1984).
95