Select ON to have the machine dial and begin transmission while scanning is
still in progress, or OFF to have the machine wait until all pages have been
scanned. Press
♦
Initial setting: ON
Setting 24: MULTI TTI
If you are using Department Control, you can select ON to have the
department name (the name associated with the department code entered by
an operator to access the fax) appear at the top of each transmitted
document. This will appear in place of the name entered in Entering Your
Name and Fax Number in Chapter 1. Select OFF to turn Multi TTI off (the
sender's name entered in Chapter 1 will appear). Press
make the selection and then press
♦
Initial setting: OFF
Setting 25: BEEP LENGTH
This sets the duration of the beep that signals the end of transmission,
reception, and copying. Press
SECONDS, 1 SECOND, or NO BEEP) and then press
♦
Initial setting: 3 SECONDS
Note: Setting 26 is not used.
Setting 27: DEPARTMENT CODE DIGITS
This setting allows you to change the number of digits used for Department
Codes. Enter any number from
♦
Initial setting: 4
or
to make the selection and then press
START/
.
ENTER
or
to
3
9
Optional Settings
or
to select a duration (3
START/
.
ENTER
.
START/
.
ENTER
to
177