Entering And Using Programs - Sharp FO-DC500 Facsimile Operation Manual

Entering and Using Programs

Entering and Using Programs
If you frequently perform the same operation involving the same party, you can
program all the steps of the operation into one Program Key. This allows you to
perform the operation by simply pressing that key.
♦
Any Rapid Key which is not already programmed as a Rapid Key or a
Group Key can be used as a Program Key.
♦
You can include a timer setting in the program to have the operation
performed automatically at a selected time.
♦
To clear a mistake in the procedures that follow, press
Initial procedure
To program a Program Key, first perform the following procedure. After you
have completed this procedure, go to the procedure for the specific operation
you want to program (see the following pages).
1
MENU
Press
until PROGRAM/GROUP MODE is
selected in the display.
2
START/
Press
ENTER
3
Make sure that PROGRAM ENTRY
MODE is selected and then press
START/
.
ENTER
4
Make sure that "SET" is selected and
then press
154
and then
.
START/
.
ENTER
Display:
or
MENU MODE
2:LISTING MODE
3:ENTRY MODE
4:OPTIONAL SETTING
5:PROGRAM/GROUP MODE
PROGRAM/GROUP MODE
1:PROGRAM ENTRY MODE
2:GROUP ENTRY MODE
PROGRAM ENTRY MODE
1=SET
2=CLEAR
PROGRAM SET
PRESS PROGRAM KEY
STOP
.