Audible Signals - Sharp AM-400 Online Manual

Messages and Signals
REMOVE /
BYPASS PAPER
(alternating messages)
SET BYPASS PAPER /
SIZE: XXXX
(alternating messages; a
paper size appears in
"XXXX")
SYSTEM ERROR [XX]
(a number appears in
"XX")
TONER EMPTY
TONER NEAR EMPTY
TOTAL PAGE(S) 01

Audible signals

Continuous tone
Intermittent tone
(3 beeps)
Rapid intermittent
tone
146
A fax has been received to memory because paper is
inserted in the bypass tray (faxes cannot be printed
while paper is in the bypass tray). Remove the paper
from the bypass tray to allow the fax to be printed.
Paper must be inserted in the bypass tray for a print
job or copy job that requires use of the bypass tray.
Insert the indicated size of paper in the tray.
If this message appears, unplug the power cord, wait
about 10 seconds, and then plug it back in. If the
message still appears, unplug the power cord and call
for service.
The toner cartridge must be replaced. Printing will be
possible (although the output will be increasingly
faint) until a fax is received. Once a fax is received, it
will be held in memory and printing will not be
possible until the toner cartridge is replaced.
The toner cartridge is almost out of toner
(approximately 200 pages can be printed).
Number of fax pages transmitted or received.
3 seconds
5 seconds
(1 second on, 1
second off)
35 seconds
(0.7 seconds on,
0.3 seconds off)
Indicates the end of fax transmission or
reception.
Indicates incomplete fax transmission
or reception.
Indicates that an extension phone
connected to the machine is off hook.