Operating The Switch; Turning The Switch On And Off; Interpreting Led Activity - HP StorageWorks 8B - FC Entry Switch Reference Manual

Fc 1gb/2gb
Hide thumbs Also See for StorageWorks 8B - FC Entry Switch:
Table of Contents

Advertisement

Operating the Switch

This chapter provides the following information:

Turning the Switch On and Off

To turn the FC Entry Switch 8B or FC Switch 8B on, connect the power cable to the power
connector on the switch and to a power source. The switch takes approximately 4.5 minutes to boot
after it is turned on.
To turn the switch off, disconnect the power cable from the power source.
Note:

Interpreting LED Activity

System activity and status can be determined through the activity of the LEDs on the switch.
Note:
The switch includes the following LEDs:
Installation and Reference Guide
Turning the Switch On and Off
Interpreting LED Activity
on
Interpreting POST Results
on
Maintaining the Switch
on
page 3-5
Removing all power from the switch triggers a system reset. When power is restored, all
devices are returned to the initial state and the switch runs POST, a system check that lasts
approximately 2.5 minutes.
POST can be skipped by using the fastboot command. For more information about this
command, refer to the Fabric OS Reference Manual. A fast boot requires approximately
two minutes to complete.
The LEDs may flash yellow during diagnostic tests, and green, yellow, or orange during
POST. This is normal, and does not indicate a problem unless the LEDs do not display a
healthy pattern after POST or the other diagnostic tests are complete.
The orange light may be referred to as "amber" in other documentation.
Eight port status LEDs on the SFP media side (above and to the left of each port) to
indicate the status of each port.
Eight port speed LEDs on the SFP media side (above and to the right of each port) to
indicate the current link speed of each port.
One switch status LED on the SFP media side and one on the fan side, to indicate whether
the switch is on and has successfully booted, and whether any of the ports are faulty.
Two Ethernet port LEDs, one to show link speed and one to show link status.
on
page 3-1
page 3-1
page 3-4
Chapter
3
3-1

Advertisement

Table of Contents
loading

This manual is also suitable for:

SurestoreFc 1gb switch 8bFc 2gb switch 8b

Table of Contents