GE PT920 Owner's Manual page 37

Care and Cleaningof the Oven ge.com
Be sure electrical power is off and aft surfaces are cool before cleaning any part of the oven.
How to Remove Protective Shipping Film and Packaging Tape
Careflllly grasp a corner of the protective
shipping fihn with your finge_ and slowly
peel it from the appliance surlhce. Do
not use any shaI I) itelns to relnove tile
fihn. Remove all of the fihn befln'e using
tile appliance fin" tile fii_t dine.
To assure no damage is done to tile
finish of the product, the satest way to
remove the adhesive fl'om packaging
tape on new appliances is an application
of a household liquid dishwashing
detergent. Apply with a sott cloth and
allow to soak.
NOTE:The adhesive mustbe removed fromaft
parts.Itcannotbe removed if it isbakedon.
, , Socket
|
|
,/.,, ¢2 i
/2 .
Maximum/' '_ ',
engtl _ ,,
, Bulb ',
Glass c over
Oven Light Bulb
NOTE: Theglass cover(on some models)should
be removedonly when cold. Wearinglatex gloves
may offer a better gn)
Bed)re repladng tile bulb, disconnect
electrical power to the oven at the main
tuse or circuit breaker panel. I,et the
bulb cool completely bed)re removing it.
For your satbQ:, do not touch a hot bulb
with a damp cloth. If you do, tile bulb
will break.
Toremove:
Tm'n tile glass cover counterclockwise
1/4 turn tmtil tile tabs of tile glass cover
clear the grooves of the socket. Remove
tile bulb.
Toreplace:
Put in a new 40-watt appliance bulb.
Place the tabs of the glass cover into the
grooves of tile socket. Tm'n tile glass
cover clockwise 1/4 turn.
NOTE."
iJG A 40-watt appliancebulb is smallerthan a
standard 40-watt householdbulb.
i':':: I nstafland tighten the coverclockwise.
iJG Reconnectelectrical power to the oven.
iJG Foriknprovedflghtlbg inside the oven,clean
the glass cover frequent/)/using a wet cloth.
Thisshou/d be done when the oven is
completelycool.
37