GE PT920 Owner's Manual page 11

Ondoubleovenmodelsonly.
f-r][Z]bJLJbJ
[BALdLdU
DULdUU
ge.com
How to Set the Oven For Roasting When Using the Probe
[] Insert the probe into the fi)od, See
the Using
theProbe
section.
[] Plug the probe into the Otlflet in the
oxen. Make sure it's pushed all the
wa_ in, Close tile oxen door.
[] Touch PROBE
For double oven models only,
touch UPPEROVEN or LOWER OVEN
to select tile desired o_en,
[]
[]
[]
[]
[]
Tile
Touch tile numbei_ to set tile
desired internal fi)od or meat
temperatm'e. (Tile maximmn
internal temperature tot tile
tood that you can set is 200°E)
Touch ENTER.
Touch BAKE.
Touch tile numbets to set tile
desired oxen temperature.
Touch
ENTER.
screen will prompt if tile probe is
inserted into tile outlet and you haxe not
set a probe temperature and touched
ENTER.
For double oven models only, to set tile
second oven, select PRESS TO MAKE
LOWER OVEN SELECTIONS or PRESS TO
MAKE UPPER OVEN SELECTIONSas
needed and tollow tile above steps.
Tile set temperature may be changed
b 7 touching
CHANGE TIME-TEMP fi,r tile
ai)i)ropriate oven.
The settings may be cancelled by
touching CANCELfi,r tile al)l)ropriate
oven.
Tile timer can be set by touching SET
KITCHEN TIMER. See the Kitchen Timer
section.
A CAUTlON:Topreventposel le
burns,donot unplug theprobefromtheoven
outletuntiltheovenhascoolecL Donotstorethe
probein theoven.
;;Ji:_ If theprobeisremoved fromthe foodbefore
thefinal temperature/s r eached, a tonewill
sound and thescreen will promptuntilthe
probeisremoved from theoven.
;;Ji:_ You canusethetimereventhoughyoucannot
usetimedovenoperations.
[]
Touch
START
Tile o_en will turn on immediately and
stm on tmtil tile o_en is turned off.
Tile convection tim will mrn on (after
a short delay) and 100°F will appear in
tile screen. (Tile temperature display
will start to change once tile internal
temperature of tile meat reaches 100°E)
_Mter tile internal temperature of tile
meat reaches 100°g the changing
internal temperature will be shown in
tile display.
[] _4q/en tile internal temperature of
tile meat reaches tile number you
have set, the probe and the oven
ttlI'n ()_ and
tile
oven control
signals. To stop the signal, touch
tile CLEAR/OFFpad. Use hot pads u)
remove tile probe ti'om tile food.
Do not rise tongs to pull on it--
they might damage it.
11