Download Print this page

GE JKP30 Installation Instructions

27" & 30" electric built-in wall ovens
Hide thumbs

Advertisement

Installation Instructions

27"
30" Electric Built-In Wall Ovens
Questions?
Call 1.800.GE.CARES (1.800.432.2737) or visit www.GEAppliances.com
In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca
• Note to Consumer – Keep these
BEFORE YOU BEGIN
instructions for future reference.
Read these instructions completely and
• Skill level – Installation of this appliance
carefully.
requires a qualified installer or electrician.
IMPORTANT —
Save these
• Proper installation is the responsibility
instructions for local inspector's use.
of the installer.
IMPORTANT —
• Product failure due to improper installation
Observe all
is not covered under Warranty.
governing codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with Consumer.
All electric wall ovens must be hard-wired (direct-wired)
into an approved junction box. A plug and receptacle is NOT permitted on these products.
FOR YOUR SAFETY:
WARNING:
Before beginning the installation, switch power off at the service
panel and lock the service disconnecting means to prevent power from being switched on accidentally.
When the service disconnecting means cannot be locked, securely fasten a prominent warning device,
such as a tag, to the service panel.
Be sure the oven is securely installed in a cabinet that is firmly attached to the house structure.
Weight on the oven door could cause the oven to tip and result in injury. Never allow anyone to climb,
sit, stand or hang on the oven door.
Make sure the wall coverings, counters and cabinets around the oven can withstand the heat
(up to 200°F [93.3°C]) generated by the oven.
MATERIALS YOU MAY NEED
TOOLS YOU MAY NEED
Junction Box
1/8" Drill Bit and Electric or Hand Drill
Wire Nuts
Phillips Screwdriver
Strain Relief Clamp for 1/2" Conduit
Wire Strippers
36" (91 cm) of String
1
REMOVE PACKAGING MATERIALS
Failure to remove packaging materials could result in damage to the appliance. Remove all
packing parts from oven, racks and heating elements. Remove protective film and labels on the
outer door and control panel. Also, remove plastic on trims and panel, all tape around the oven
and any shipping screws securing the oven to the base pad. Open oven door and remove
literature pack and oven racks. Remove the bottom trim from the top of the oven. It will be
installed at the end of the installation process. The trim is wrapped separately and taped
to the top of the unit.
2
C
CUTOUT FOR DOUBLE OVENS
(2 Thermal Ovens)
If the cabinet does not have a front frame and the sides are less than ¾" (1.9 cm) thick,
shim both sides equally to establish the cutout width.
27" (68.6 cm)
30" (76.2 cm)
25" (63.5 cm) min.
28
1
" (72.4 cm) min.
2
25
1
" (64.1 cm) max.
28
5
" (72.7 cm) max.
4
8
49
11
" (126.2 cm) min.
51
13
" (131.6 cm) min.
16
16
50
1
" (127.3 cm) max.
51
15
" (131.9 cm) max.
8
16
1" (2.5 cm)
11
" (1.75 cm)
16
20" (50.8 cm) min.
21" (53.3 cm) min.
1" (2.5 cm) min.
1" (2.5 cm) min.
1" (2.5 cm) min.
1
1
" (3.2 cm)
4
8
3
" (22.2 cm) max.
9
1
" (24.1 cm) max.
4
2
right side only
right side only
44" (111.8 cm)
47" (119.4 cm)
13
1
" (33.7 cm)
12" (30.5 cm)
4
31-10730-1
08-09
JR
DESIGN INFORMATION
SINGLE OVEN INSTALLATIONS
The single oven may be installed in a cabinet alone or above a warming drawer. The single oven may
also be installed below a countertop or below specified cooktops. See the label on top of the oven for
approved models.
DOUBLE OVEN INSTALLATIONS
A double oven may be installed in a cabinet alone or above a warming drawer. See the label on top of
the oven for approved models.
IMPORTANT: Always refer to individual installation instructions packed with each product for specific
requirements.
2
PREPARE THE OPENING (FOR INDOOR USE ONLY)
If the cabinet does not have a solid bottom,
2" x 4" (5 cm x 10 cm)
two braces or runners must be installed to support
or Equivalent Runners Level
with Bottom of Cutout
the weight of the oven. For single ovens, the runners
and braces must support 200 lbs (91 kg). For double
ovens, the runners and braces must support 375 lbs.
C
L
(170 kg).
If marks, blemishes or the cutout opening are
visible above the installed oven, it may be necessary
to add wood shims under the runners and front trim
until the marks or opening are covered.
If the cabinet does not have a front frame
and the sides are less than ¾" (1.9 cm) thick, shim
both sides equally to establish the cutout width.
Suitable
Bracing
to Support
Runners
21 5/8"
(54.9 cm) Over
Centerline
of Cabinet
2
D
CUTOUT FOR DOUBLE OVENS
(with Upper Microwave Oven)
If the cabinet does not have a front frame and the sides are less than ¾" (1.9 cm) thick,
shim both sides equally to establish the cutout width.
27" (68.6 cm)
30" (76.2 cm)
25" (63.5 cm) min.
28
1
" (72.4 cm) min.
2
25
" (64.1 cm) max.
28
" (72.7 cm) max.
1
5
4
8
41
1
" (104.5 cm) min.
42
3
" (107.2 cm) min.
8
16
41
1
" (104.8 cm) max.
42
1
" (107.3 cm) max.
4
4
1" (2.5 cm)
" (1.75 cm)
11
16
20" (50.8 cm) min.
21" (53.3 cm)
1" (2.5 cm) min.
1" (2.5 cm) min.
1" (2.5 cm) min.
1
1
" (3.2 cm)
4
8
3
" (22.2 cm) max.
9
1
" (24.1 cm) max.
4
2
right side only
right side only
2
A
CUTOUT FOR SINGLE OVENS IN WALL CABINET
If the cabinet does not have a front frame and the sides are less than ¾" (1.9 cm) thick,
shim both sides equally to establish the cutout width.
These ovens are not
approved for stackable
installations.
Side-by-Side Installations (30" only)
Install two ovens in separate cutouts.
Center Line
Center Line
30.5" (77.5 cm)
Cutout –
Cutout –
observe all
observe all
dimensions and
dimensions and
requirements.
requirements.
2" (5.1 cm) Min.
27" (68.6 cm)
30" (76.2 cm)
25" (63.5 cm) min.
28
1
" (72.4 cm) min.
2
25
1
" (64.1 cm) max.
28
5
" (72.7 cm) max.
4
8
27
5
" (70.2 cm) min.
27
1
" (69.2 cm) min.
8
4
28
1
" (71.4 cm) max.
27
5
" (69.4 cm) max.
8
16
1" (2.5 cm)
11
" (1.75 cm)
16
20" (50.8 cm) min.
21" (53.3 cm) min.
1" (2.5 cm) min.
1" (2.5 cm) min.
1" (2.5 cm) min.
1
1
" (3.2 cm)
4
8
3
" (22.2 cm) max.
9
1
" (24.1 cm) max.
4
2
right side only
right side only
2
E
CUTOUT FOR INSTALLATION OVER A WARMING
DRAWER
Install the oven only with specific models listed on the label located on top of the oven.
Additional clearances between cutouts may be required. Check to be sure the oven
supports above the Warming Drawer location do not obstruct the required interior depth and
height.
When installing a Warming Drawer below a single or double oven, a separate 120V, 60 HZ,
properly grounded receptacle must be installed. Refer to installation instructions packed with
the Warming Drawer for specific installation requirements.
Anti-Tip Block Against
Rear Wall Per Warming
Drawer Requirement
2" (5.1 cm)
Min.
Per Warming
Drawer
Requirement
2
B
CUTOUT FOR SINGLE OVENS – UNDER COUNTER
These ovens are only approved to be installed under the specific models as labeled on
the unit.
Side-by-Side Installations (30" only)
Install two ovens in separate cutouts.
Center Line
Center Line
30.5" (77.5 cm)
Cooktop
Cutout – observe
Cutout – observe
all dimensions and
all dimensions and
requirements.
requirements.
2" (5.1 cm) Min.
One cooktop may be centered over either
oven in the side-by-side installation.
25" (63.5 cm) min.
28
1
" (72.4 cm) min.
2
25
1
" (64.1 cm) max.
28
5
" (72.7 cm) max.
4
8
27
5
" (70.2 cm) min.
27
1
" (69.2 cm) min.
8
4
28
1
" (71.4 cm) max.
27
5
" (69.4 cm) max.
8
16
1" (2.5 cm)
1" (2.5 cm)
1" (2.5 cm)
1
1
" (3.2 cm)
4
1" (2.5 cm)
11
" (1.75 cm)
16
8
3
" (22.2 cm) max.
9
1
" (24.1 cm) max.
4
2
right side only
right side only

Advertisement

loading

  Also See for GE JKP30

  Related Manuals for GE JKP30

  Summary of Contents for GE JKP30

  • Page 1: Installation Instructions

    In Canada, call 1.800.561.3344 or visit www.GEAppliances.ca DOUBLE OVEN INSTALLATIONS A double oven may be installed in a cabinet alone or above a warming drawer. See the label on top of the oven for approved models. • Note to Consumer – Keep these BEFORE YOU BEGIN instructions for future reference.
  • Page 2 Position the conduit in such a manner that it will lie on top of the oven in a natural loop when the oven is installed. You will need to purchase an appropriate strain relief clamp to complete the connection of the conduit to the junction box.
  • Page 3 ¿Preguntas? también puede instalarse debajo de un mostrador de encimera o debajo de las estufas especificadas. Llame al 1.800.GE.CARES (1.800.432.2737) o visite GEAppliances.com Vea la etiqueta de la parte superior del horno para consultar los modelos aprobados. En Canadá, llame al 1.800.561.3344 o visite www.GEAppliances.ca.
  • Page 4 * Los hornos vienen equipados con un conducto de 48" de longitud. Si desea un conducto más largo, puede haber uno disponible para su modelo. Para verificar la disponibilidad o solicitar piezas, llame al 1.800.GE.CARES. CONEXIÓN DE CIRCUITO DERIVADO DE TRES CONDUCTORES Si los cables domésticos son conductores de aluminio,...

This manual is also suitable for:

Jkp30dpJkp30smssJkp30spssJkp35dpJkp35smssJkp35spss ... Show all