Adjusting The Image Angle And Automatic Keystone Correction Function - Epson EMP-74 User Manual

Adjusting the Screen Image
Adjusting the Image Angle and Automatic Keystone
Correction Function
The projector should be set up so that it is as perpendicular to the screen as
possible.
Seen from the side
10
Centre of
lens
1
Seen from above
5
5
If it is not possible to set up the projector so that it is perpendicular to the
screen, it can be set up at a slight vertical angle instead. You can extend or
retract the front adjustable feet to adjust the upward projection angle
within a maximum range of 10°.
PROCEDURE
While pressing the two foot adjust buttons at either side,
lift up the front of the projector so that the front adjustable
feet can extend.
Extend the front adjustable feet until the desired angle is obtained,
and then release the foot adjust buttons.
To retract the front adjustable feet, gently push down on the projector
while pressing the two foot adjust buttons.
Foot adjust buttons (side)
TIP
If the projector is tilted horizontally, turn the bases of the front
adjustable feet to adjust the angle. When the projector is tilted
horizontally, the correction may not be carried out correctly.
Front
adjustable foot
Extend Retract
38
p.39