NForce 610i/630i-ITX series Motherboard
Fan Connectors
There are two Fan Connectors on the motherboard. The fan speed can be detected
and viewed in the PC Health Status section of the CMOS Setup.
SYS FAN Connector
Sense
+12V
GND
Expansion Slots
The NVIDIA MCP73 motherboard contains one PCI Express x1 slot.
PCI Express x Slots(optional)
There is one PCI Express x1 slot that is designed to accommodate
less bandwidth-intensive cards, such as a modem or LAN card. The x1
slot provides 250 MB/sec bandwidth.
Jumper Settings
This chapter explains how to configure the motherboard's hardware. Before using your
computer, make sure all jumpers and DRAM modules are set correctly. Refer to this
chapter whenever in doubt.
CMOS Clear Jumper-JP1
JP1
Selection
1-2* Normal*
2-3
CMOS Clear
Close
Open
If you want to clear the system configuration,use the JP1(Clear CMOS Jumper) to clear data
Notice:
1. Be sure to save the CMOS setting when exit the CMOS.
2. If the CPU is frequency multiplier locked, no CPU speed change will be seen
even if the frequency multiplier setting in CMOS setup is changed.
4
CPU FAN Connector
Control
Sense
+12V
GND
P/S Port 5V Standby Power Jumper-JP2(Optional)
* = Default setting.
JP2
Selection
1-2* 5V standby power input*
2-3
5V power input
E V
O
M
E
R