Table of Contents
Advertisement
NForce 610i/630i-ITX series Motherboard
Front Panel Header-FP
The front panel header on this motherboard is one connector used to connect the fol-
lowing four cables:
q PWRLED
Attach the front panel power LED cable to these two pins of the connector. The
Power LED indicates the system's status.
q PWR SW
Attach the power button cable from the case to these two pins. Pressing the
power button on the front panel turns the system on and off rather than using the
power supply button.
q HDD LED
Attach the hard disk drive indicator LED cable to these two pins. The HDD indicator
LED indicates the activity status of the hard disks.
q RST SW
Attach the Reset switch cable from the front panel of the case to these two pins.
The system restarts when the RESET switch is pressed.
FP-Pin Definition
Pin
Signal
1
HDD_LED+
2
PW_LED+
3
HDD_LED-
4
PW_LED-
5
GND
Note:
S ome chassis do not have all four cables.Be sure to match the name
on the connectors to the corresponding pins.
USB Headers
This motherboard contains six USB 2.0 ports that are exposed on the rear
panel of the chassis(Figure 2). The motherboard also contains two 10-pin
internal header connectors onboard.
1. Secure the bracket to either the front or rear panel of your chassis (not all
chassis are equipped with the front panel option).
USB-Pin Definition
PIN
Assignment
1
VCC
2
VCC
3
USBP0-
4
USBP1-
5
USBP0+
Pin
Signal
6
PWR_SW
7
RESET
8
GND
9
NC
10
KEY
PIN Assignment
6
USBP1+
7
GND
8
GND
9
KEY
10
OC#
E V
O
M
E
R
LOTES
FP_U1
2
1
FP_U1
2
1
10
9
10
9
Advertisement
Table of Contents
