Hard Disk Boot Priority - Zotac nForce 630i - ITX User Manual

NForce 610i/630i-ITX series Motherboard

Hard Disk Boot Priority

Press Enter to display Hard Disk Boot Priority menu,then some of the peripheral
equipment pluged will be displayed.
q Bootable Add-in Cards
Use this option to bootable add-in cards.
q Virus Warning
Allow you to choose the Virus Warning feature for IDE Hard Disk boot sector
protection.
q CPU L&L Cache/CPU L Cache
Use these options to disable or enable L1/L2/L3 cache.
q Quick Power On Self Test
Enabling this option allows the system to skip certain test while booting, which
reduces the time needed to boot the system.
q First/Second/Third Boot Device
Use this option to set the priority sequence of the devices booted at power on.
Use the Page Up and Page Down keys to scroll through the options or press
Enter to display the sub-menu. Use the # $ arrow keys to position the selector
in the option you choose.
q Boot Other Device
With the option set to Enable, the system boots from some other device if the
first/second/third boot devices fail.
q Boot Up Floppy Seek
Enabled tests floppy drives to determine whether they have 40 or 80 tracks.
q Boot Up NumLock Status
This option allows you to select the power-on state of NumLock. Select On to
activate the keyboard NumLock when the system is started. Select Off to disable
the NumLock key.
q Gate A0 Option
Use this option to choose Gate A20 menu.
q Typematic Rate Setting
Use this option to set keystrokes repeat. if Enabled, display options as follows:
Typematic Rate
v
v Typematic delay
q Security Option
The Security Options allows you to require a password every time the system
boots or only when you enter setup. Select Setup to require a password to gain
access to the CMOS Setup screen. Select System to require a password to
access the CMOS Setup screen and when the system boots.
q APIC Mode
Use this function to enable or disable the Advanced Programmable Interrupt
Controller (APIC). If you disable this option, you also disable the MPS Version
Control for OS option.
q MPS Version Control For OS
Use this function to select the Multi-Processor Specification (MPS) version that
BIOS passes to the operating system. Use the Page Up and Page Down keys to
scroll through the options.
0