Installing The I/O Shield; Connecting Cables And Setting Switches - Zotac nForce 630i - ITX User Manual

Installing the I/O Shield

The motherboard kit comes with an I/O shield that is used to block radio frequency
transmissions, protects internal components from dust and foreign objects, and
promotes correct airflow within the chassis.
Before installing the motherboard, install the I/O shield from the inside of the chassis.
Press the I/O shield into place and make sure it fits securely. If the I/O shield does
not fit into the chassis, you would need to obtain the proper size from the chassis
supplier.

Connecting Cables and Setting Switches

This section takes you through all the connections and switch settings necessary on
the motherboard. This will include:
q Power Connections
v 24-pin ATX Power Connector-PW
v 4-pin ATX_12V power connector-PW
q Internal Headers
v Serial Port Header-COM
v SPDIF Out Header(Optional)
v Speaker Header-SPK
v Hard Disk Connector-IDE
v Front Panel Header-FP1
v USB Headers
v Front Pannel Audio Header-FP_S1
q Serial ATA II
q Chassis Fans
q Expansion slots
q Jumper settings
Hardware Installation
9