Install Table Clamps - Craftsman 113.196380 Owner's Manual

Alignment
Install Table Clamps
1. Insert fence, then spacer table, then rear
table.
2. Set out two unassembled table clamps:
- two cup washers
- two clamp brackets
- two square nuts
- two thumbscrews
3. Slip square nut into slot at top of clamp
bracket.
4. Insert thumbscrew through rear opening,
and turn clockwise until it comes out other
side about 1/2". Note: If you put screw in
front opening, clamp will not work.
Front
Table
\
Spacer Rear
Fence Table Table
Cup
Washer
Square
Nut
5. Tilt clamp bracket forward and snap into
place in opening at rear of table support.
6. Hold cup washer with concave side
against rear table. Turn thumbscrew clock-
wise until i! snaps into washer.
7. Repeat steps for other table clamp.
8. Tighten thumbscrews to clamp table sec-
tions in place.
Clamp
Bracket
Thumbscrew
3O