Make Front Tabke Flat - Craftsman 113.196380 Owner's Manual

Adjustments
5. Drop a flat washer into each counter-
bored hole.
6. Start 1-3/4" long pan head screw through
center hole and into U-clip, but do not fully
tighten.
7. Start cup point set screw through leveling
hole and into tee nut, but do not fully tight-
en.
8. Put l" long pan head screw in each of four
remaining holes and through matching holes
in table supports. On end of each screw, put
lock washer then nut and tighten with screw-
driver.
1/4-20 x !-314" 17/64"
Pan Head Screw Flat Washer
1/4-20 x 7/8" Cup Point Set
Screw
1/4-20 x 1"
Pan Head Screw
_Front Table
Make Front Table Flat
1. Place rear table on its edge, across center
of front table. Check for gap between sur-
face_
If there is less than 1/32" gap, tighten cup
point set screw until it touches frame (look
underneath table), then tighten center (1-3/4"
long) pall head screw.
If there is more than 1/32" gap, close gap
by raising or lowering center of front table:
to raise center, tighten cup point set screw
against frame;
to lower center, tighten center (1-3/4" long)
pan head screw.
2. When gap is closed, make sure cup point
set screw touches frame (look underneath
table), and center (1-3/4" long) pan head
screw is tightened.
Rear Table
Board
Hold Down Leveling I /
Screw SetScrew
o o
This concludes adjusting your saw where you have removed all "looseness" or slack between the
different parts of the saw. The next section deals with actually aligning the sawblade to get accurate
Ctl is.
27