Attaching Carriage; Lock Miter/Arm Lock Before Proceeding; Install Arm Cap And Arm Cap Trim - Craftsman 113.196380 Owner's Manual

Assembly
Attaching Carriage - Motor to Arm
Remove carriage stop screw, lockwasher and
tag. Read and understand warning tag before
discarding.
Lock miter/arm lock before proceeding.
Holding carriage assembly with both hands,
carefully start and slide the carriage onto the
tracks. The assembly must be held parallel
with the ann so that all four bearings slide
smoothly onto the arm, preventing any
excessive strain on bearings and track.
_i WARNING
Reinstall carriage stop screw and
Iockwasher to prevent carriage from
rolling off arm.
Push toward rear of
saw to lock
Miter/Arm
Lock Lever
Remove two (2) motor packing studs that
are threaded into boltom of motor.
Install arm cap and arm cap trim
_i WARNING
Make certain power cord is
unplugged.
1. Insert finger under left end of switch lever
and pull out to the "ON" position.
2. Place arm cap in position and install with
(2) 10-32 x 7/8 self threading screws.
3. Push switch to "OFF" position.
Bottom
of Motor
Arm Cap
_ Screw
17