Mounting Table Clamps - Craftsman 113.198111 Operator's Manual

8. Install the pan head bolts through the
other four mounting holes. Put a lockwasher
and hex nut on each bolt and tighten using a
Phillips screwdriver. (Figures 45 & 49)
Fig. 49 - Pan Head Bolt
9. Lay the edge of the rear table across the
center of the front table, and check to see if
there is a gap between the two. (Figure 50)
13. If there is a gap larger than 1/32 inch, go
back to step 11 and repeat, or
If there is a gap less than 1/32 inch, or no gap
at all, go to the next section.
Mounting Table Clamps
The following parts are used in mounting the
table clamps:
A Table Clamps .................. 2
B Washer ....................... 2
C Locknut ...................... 2
Fig.51
1. Place the table clamp in the hole provided
at the rear of the right table support. (Figure
52)
Fig. 50
10. If there is a gap larger than 1/32 inch, go
to
step
11, or
2. Put a washer and locknut on the table
clamp and tighten using a 1/2 inch wrench or
socket. (Figure 52)
If there is a gap less than 1/32 inch, or no gap
at all, tighten the leveling screw and the cen-
ter mounting screw. Do not overtighten. Then
go to step 12.
l 1. If the gap is at the center of the table,
tighten the leveling screw until the gap is
gone. Then tighten the center mounting screw
and go to step 12, or
Table Support
Table Clamp
If the gap is at the sides of the table, tighten
the center mounting screw until the gap is
gone. Then tighten the leveling screw and go
to step 12.
12. Lay the edge of the rear table across the
center of the front table and check again for
gaps.
3. Repeat steps l and 2 with the left table
clamp. (Figure 52)
21