Assembly
Install Rip Scale Indicators,
Table
Clamp Screws,
and Dust Elbow
1. Set out:
-two rip scale indicators
-two table clamp
screws
-two table clamp washers
-dust elbow.
2. Slide one indicator onto each side of
blade carriage.
3. From rear, screw table clamp screws
through holes in table clamp mounts,
until screw protrudes enough to tap on
washer. Note: Concave side of washer
faces table edge.
. Rip Scale
Indicator
Table Clamp
Screw
/
Table Clamp
Screw Mount
Radial Arm
/
Blade
Carriage
Table Clamp
Washer
4. Push dust elbow onto opening on top
of guard.
You cannot use the saw until it is
aligned. Go to Alignment
and Adjust-
ment Section and follow all instruc-
tions. It may be helpful to read the
Controls
Section before proceeding
with alignment
and adjustment.
Dust Elbow
23