Finishing And Feeding Equipment; Interface Requirements; Channel-Attached; Third Party Connections - Xerox DocuPrint 96 Installation Planning Manual

Finishing and feeding equipment

Interface requirements

Channel-attached

Third party connections

XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS INSTALLATION PLANNING GUIDE
It is important to note that while the Bypass Transport and Input
Enablement options provide you with an interface between your
DocuPrint 96/DocuPrint 96MX LPS and your finishing and feeding
accessories, they require their own AC and DC power sources. The
power must be independent of your DocuPrint 96/DocuPrint 96MX
LPS.
Consult your Xerox or Xerox Limited sales representative, as well as
the sales representative of the company from which you purchased
your finishing and feeding equipment, for specific electrical and
space requirements.
This section describes the System interface requirements for
Channel-attached or Third Party connection for the printer.
For an online configuration with an IBM host system, the following
cables must be available:
•
Bus and tag cables (bus in, bus out, tag in, tag out)
•
Emergency power off (EPO) cable (optional)
•
Terminators (if necessary, due to location on channel).
For your convenience, it is possible to order the Bus and Tag cables
for the printer through Xerox Corporation on a purchase-only basis.
Contact your Xerox or Xerox Limited sales representative for current
pricing and order information.
Xerox supports a number of third party connections. For more
information, contact your Xerox or Xerox Limited sales
representative or call the Xerox Connection between 7 a.m. and 4
p.m. Pacific time using the following telephone number:
1-800-451-9312 (continental U.S.)
PREINSTALLATION
3-23