Xerox DocuPrint 96 Installation Planning Manual page 39

PREINSTALLATION
Figure 3-8 shows the minimum service space required between two
DocuPrint 96/DocuPrint 96MX printers positioned face-to-face. The
printers should be separated by at least 74 inches/1880 mm. This
allows enough space for the front panels of one printer to be opened,
without obstructing the 24 inch/610 mm operator area of the other
printer.
Figure 3-8. Face-to-face shared service area space
When determining your space requirements and planning for shared
space between your LPS, it is important to consider all the
components you plan to have installed. If you have an optional
bypass transport or input enablement device on your DocuPrint 96/
DocuPrint 96MX LPS, you need to consider the size and
configuration of the finishers and feeders you purchase. A finisher
can add considerable length to your LPS and possibly consume
space in front of your LPS. Your feeder may require a large amount
of space behind your LPS.
The 36-inch/914-mm clearance space around each component must
be observed for your feeders and finishers, therefore, must be
considered when planning configuration of your systems. To ensure
all the space requirements are met, it is important to work with your
Xerox or Xerox Limited representatives, as well as the
representatives of the company from which you have purchased your
finishers and feeders.
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS INSTALLATION PLANNING GUIDE 3-9