Miter Lock Handle; Dust Guide - Craftsman 315.212380 Operator's Manual

Asmentioned previously, thesawhasbeenfactory
assembled a ndadjusted. Themiterlockhandle, d ust
guide, a ndbladearetheonlyparts thathaveto be
installed.
MITER LOCK HANDLE
See Figure 14.
Cut the tie-wraps holding the saw arm and the miter
lock in place. To install the miter lock handle, place the
threaded stud into the threaded hole in the control arm.
Turn clockwise to tighten.
EXHAUST
PORT
DUSTGUIDE
CONTROL
ARM
TO
LOOSEN
TO
TIGHTEN
0
MITERTABLE
MITER
LOCKHANDLE Fig. 14
DUST GUIDE
See Figure 15.
To install the dust guide, place the end marked iNSERT
over the exhaust port in the upper blade guard. Turn the
guide so that the open end is facing down or toward the
rear of the saw.
Fig. 15
DUST BAG
See Figure 16.
A dust bag is provided for use on this miter saw. It fits
over the dust guide on the upper blade guard. To install,
squeeze the two metal clips to open the mouth of the bag
and slide it on to the dust guide. Release the clips. The
metal ring in the bag should lock in between the grooves
on the dust guide.
To remove the dust bag for emptying, simply reverse the
above procedure.
DUSTGUIDE
DUSTBAG
Fig. 16
18