Miter Lock Handle - Craftsman 315.212120 Owner's Manual

• Using a 6 mm hex key, loosen the socket head
screws secudng the fence. See Figure 16. Adjust
the fence left or dght until the framing square and
zero clearance throat plate are parallel.
• Retighten the screws securely and recheck the
fence-to-table alignment.
6 mmSOCKET
HEADSCREWS
6 mmSOCKET
HEADSCREWS
Fig. 16
SQUARING THE SAW BLADE TO THE
FENCE
See Figures 17- 20.
• Unplug your sew.
& WARNING: Failure to unplugyour sew could
result in accidental startingcausing possible
serious personal injury.
• Pull the sew arm all the way down and engage
the lock pin to hold the saw arm in transport
position;
Loosen the miter lock handle approximately
one-half turn.
Depress the miter lock plate and rotate the miter
table until the pointer on the control arm is
positioned at 0 °.
Release the miter lock plate and securelytighten
the miter lock handle.
• Lay a framing square fiat on the miter table. Place
one leg of the square against the fence. Slide the
other leg of the square againstthe fiat pert of sew
blade.
Note: Make sure that the square contacts the fiat
part of the sew blade, not the blade teeth.
FENCE
FRAMING
SQUARE
MITER BLADE
TABLE MITER
LOCKPLATE
FENCE
MITER
VIEWOFBLADE LOCK HANDLE
SQUARE WITHFENCE Fig. 17
MITER BLADE
TABLE MITER
LOCKPLATE
VIEWOFBLADE NOTSQUARE WITH
FENCE, A DJUSTMENTS AREREOUIRED Rg. 18
MITER BLADE
TABLE MITER
LOCKPLATE
VIEW OF BLADE NOT SQUARE WITH
FENCE,ADJUSTMENTSARE REQUIRED
Fig. 19
16