Craftsman 315.212380 Operator's Manual page 19

TABLE EXTENSIONS
See Figures 17- 18.
If you plan to use the stop block, slide the stop block on
the back arm of the desired table extension first.
To install table extensions, insert the ends of extensions
into the holes in the sides of the base. Adjust the
extensions to the desired length.
Secure them in place by positioning a clamp bracket
under each table extension beneath the miter table. Orient
each clamp bracket as shown in figure 18.
Secure each clamp bracket in place with a clamp bracket
screw. The clamp bracket screw threads through the
clamp bracket and tightens against bracket support on
bottom of miter table, securing clamp bracket against
table extension.
_b, WARNING: When using the work clamp with the
stop block, install the clamp on the same side as
the stop block. This will eliminate the possibility of
trapping the workpiece, resulting in the saw blade
and workpiece kicking up. Failure to heed this
warning can result in serious personal injury.
TABLE
EXTENSION
\
TABLE
MITERSAW BASE
Fig. 17
MITER SAWBASE
TABLE
EXTENSION
BRACKET
SUPPORT
CLAMP
BRACKET
CLAMP
BRACKET SCREW
SAWVIEWEDFROMBOTTOM
Fig. 18
19