Craftsman 315.212380 Operator's Manual page 5

[] NEVER handholda workpiece t hatistoo small t o be
clamped. K eephands clearof thecuttingarea.
[] NEVER reachbehind, u nder, o r withinthreeinches
ofthe bladeanditscuttingpathwithyourhands and
fingers foranyreason.
[] NEVER reach to pickupa workpiece, a pieceof scrap,
or anything elsethatis in or nearthecuttingpathofthe
blade.
[] AVOID AWKWARD
OPERATIONS AND HAND
POSITIONS where a sudden sup could cause your
hand to move into the blade. ALWAYS make sure you
have good balance. NEVER operate your miter saw
on the floor or in a crouched position.
[] NEVER stand or have any part of your body in line with
the path of the saw blade.
[] ALWAYS release the power switch and allow the
saw blade to stop rotating before raising it out of the
workpiece.
[] DO NOT TURN THE MOTOR SWITCH ON AND OFF
RAPIDLY. This could cause the saw blade to loosen
and could create a hazard. Should this ever occur,
stand clear and allow the saw blade to come to a
complete stop. Disconnect your saw from the power
supply and securely retighten the blade bolt.
[] IF ANY PART OF THIS MITER SAW IS MISSING or
should break, bend, or fail in any way, or should any
electrical component fail to perform properly, shut off
the power switch, remove the miter saw plug from the
power source and have damaged, missing, or failed
parts replaced before resuming operation.
[] ALWAYS STAY ALERT! Do not allow familiarity (gained
from frequent use of your saw) to cause a careless
mistake. ALWAYS REMEMBER that a careless fraction
of a second is sufficient to inflict severe injury.
[] MAKE SURE THE WORK AREA HAS AMPLE
LIGHTING to see the work and that no obstructions
will interfere with safe operation BEFORE performing
any work using your saw.
[] ALWAYS TURN OFF THE SAW before disconnecting
it to avoid accidental starting when reconnecting to
power supply. NEVER leave the saw unattended while
connected to a power source.
[] THIS TOOL should have the following markings:
a) Wear eye protection.
b) Keep hands out of path of saw blade
c) Do not operate saw without guards in place.
d) Do not perform any operation freehand.
e) Never reach around saw blade.
f) Turn off tool and wait for saw blade to stop before
moving workpiece or changing settings.
g) Disconnect power (or unplug tool as applicable)
before changing blade or servicing.
h) No load speed.
[] ALWAYS carry the tool only by the carrying handle.
[] AVOID direct eye exposure when using the laser guide.
[] IF THE POWER SUPPLY CORD IS DAMAGED, it
must be replaced only by the manufacturer or by an
authorized service center to avoid risk.
[] SAVE THESE INSTRUCTIONS. Refer to them
frequently and use them to instruct others who may
use this power tool. If you loan someone this power
tool, loan them these instructions also.
_IL WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities
contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these
chemicals are:
• lead from lead-based paints,
crystalline silica from bricks and cement and other masonry products, and
arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure
to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust
masks that are specially designed to filter out microscopic particles.